What is a jib boom

Meaning of "jib boom" in the English dictionary

10 BOOKS WITH "JIB BOOM" IN ASSOCIATION WITH

Discover the use of jib boomin the following bibliographical selection. Books with jib boomrelated and brief extracts from the same to provide context of its use in literature.

1

Constitution - All Sails Up and Flying

xcerpt: Flying Jib boom. Lasha block to the jib boom end through which reeve a heel rope. Bend it to the heel of the flying jib boom end and stop it to the end of the jib boom. Man the heel rope. Sway & light out until the jib of the jib boom end is ...

2

Operator's Manual: Crane-shovel, Basic Unit, Truck Mounted ...

Reeve the cable to the jib boom strut and secure it to the dead end socket on the jib boom strut. Position in the proper hole to give the desired jib boom angle. (2) Reeve the upper jib boom point support cable from the jib boom strut to the dead ...

3

The Language of Sailing

A. jib boom is an extension of the bowsprit used for setting a jib. Ajib club is a small boom used on the foot of a jib. A jib down- haul is a rope used for hauling down the jib. A jib guy is a stout rope to support the jib boom. A jib halyard is that ...

4

The Ship Model Builder's Assistant

set off horizontally to port, and on the end of this flying jib boom was a cap, set off to starboard, through which the jib-of -jib boom extended, its inner end extending in, parallel to the flying jib boom and butting against the jib boom cap. In actual ...

5

Operator and Organizational Maintenance Manual: ...

Forward brakeband. tension, jib strut, jib boom, and jib boom suspension cables. Maximum length of boom to which a jib may be attached is 60 feet. (2) installation. (a) Install crane boom (para 4-56) and hook block (para 4-55). (6) Secure jib ...

6

An Introductory Outline of the Practice of Ship-building, & c. & c

Upon the Flying Jib boom. 455. The flying jib boom, in general, steps in the cap; when its length is% the jib boom, and% the given length of the flying jib boom. The outer and inner ends are made% of the given diameter, and its given ...